Hondata

Thanks mate, will give that a go.

Hey all,

I've got a DC5R with a JRSC @ 9psi 725cc ID injectors.
Car starts first turn when cold. But when the car has been sitting for about an hr or two, half warm, the car will take about 5 cranks to start.

Attached is a screenshot of my current cranking pulses. What would be recommended to ...

I've just upgraded to a K-PRO 3, how do I go about wiring my AEM UEGO wideband into the ecu?

Do I just wire it to one of the analogue inputs and I'm good to go? Or do I need to remove the two little blue resistors just like the standard k-pro?

photo of ecu attached
lemmiwinks, as you're probably worked out by now you do not have a Hondata product. The photo you sent is of a counterfeit KPro. More than likely, this is the cause of your problems.

Here are the differences we've found between a genuine KPro and counterfeit KPro:
http ...

photo of ecu attached

yep.. would be great if hondata let us know when to expect a new version. If more people can provide the list that is required for the posting guidelines, Hondata can rectify the problem even faster.

I've lost a lot of money getting mechanics to diagnose my car only for them to find no problems ...

Kpro serial number: 05005017
ECU: 37820-PRB-Q02 2069 300068
kmanager: 3.0.3.0
kal: attached
datalog: attached
Car: Honda integra DC5R
Mods: JRSC, AEM wideband, ID725cc injectors

Car starts and instantly dies

I've also got the exact same issue.

Car would start, then stall instantly. Now in kmanager my ignition status is always off.

Also got a 4507 Rev13d

Hello,

Just wanted to know if it is possible to transfer a kpro chip from one ecu to another. More specifically, a PND ecu with a kpro installed, transferred to a PRB ecu for the 6 speed reverse lock out. Obviously it would have to be resoldered into the new ecu.

Thanks

Spunkster wrote:Please email a picture of the inside of the ECU to support <at> hondata.com.

email sent.

Serial number of ecu is 37820-pnd-a06 2062-602400. Also has some other numbers written on the ecu case: 590-59317

Purchased privately. Not sure where it was installed. Will get serial no. Once I get home.

So I purchased a DC5 PND ECU with a brand new K-pro fitted. When I try to upload a calibration or erase, i get a "upload / erase failed" error.

The software detects the ECU and says "online, and ignition on" at the bottom of the screen. But I just can't erase or upload.

Software is up to date ...

On the ecu in my DC5R at the moment? Or the sellers one? If sellers, no idea.

Hello,

I'm after a KPRO for my DC5R, I've come across one that is a KPRO PND ECU.

According to the hondata website, this ecu is for the base model DC5.

Would I be able to use this on my DC5R?

Thanks