Hondata

hey yall im trying to figure out how to control boost, im using a hondata electronic boost controller and im using kpro with my ep3 civic si with the k20a3. if anyone knows how to set up the boost settings please help. i cant get it to go over 1psi

do you have any advice on what sensor could cause this problem?? i sent the ecu in to you guys and you said it was good so thats not the problem. a new starting point would be great as this is my only vehicle.

Does anyone have the diagram for the fuse panel underneath the steering wheel? mine is gone.

i got a new ECU and the car runs now, will flood from running the 600cc injectors though. Now i need Kpro swapped over from the old ECU to the new one. how do i go about getting this done

so i took my car into a car repair place, they said the ecu should be sent to you guys to check it. is this possible?

Here is a datalog with me driving it, hopefully this will help you guys help me cause i am lost.

so i checked voltage at the map sensor with it unhooked and the key turned on. it had 5.07 volts. what other checks are there??

I have a stock map sensor. Should i just upgrade to the hondata one?

the problem happens right around 3m 40 seconds

ok tried that and it still dies when i gave it partial throttle to back the car up. im uploading the datalog, looks like the a/f ratio spikes right before it dies everytime.

Hondata Serial #10881
version 3.1.1.0
ECU# 37820-pnf-a12
142471-3y10

I unhooked the wires from the boost controller and put it back to how it was but its still doing the same thing

Everything was working great until i wired the boost controller in, now it just dies without warning just like turning the key to accessories. Will upload the ecu info when i get home

Also car is a 2004 civic si with K20a3 revhard turbo kit. Im running hondata kpro as well. No check engine lights come on just dies out of nowhere

I installed the hondata boost controller and hooked it up as the instructions said, now my car will not idle or run while not on WOT. im stumped i have tried reloading the rev hard base map but still it dies. any help would be great!