Hondata

after trying out everything, finally decided to remove ecu and open it, upon closer inspection i noticed on the kpro board IC number FB4 is toasted! This is totally unacceptable, kpro is only like 3weeks old, from new i had it placed it the dc5 itr's oem ecu location and dint touch it once, did some ...

From Help, About, what version of software are you using? When was the last time you rebooted your laptop?

i changed the cable, tried another laptop, using the normal kpro software version 3.3 if not mistaken, still not working. latest error message states 'device that connected to has ...

Hey guys, everything was working fine, been datalogging etc for the last week. Strangely this morning, i plug the usb cable in laptop, put ignition on. it states drivers installed, but it stays offline. Tried reloading drivers, tried reloading kpro program etc, all still persists

Name: Bilal ...

ok guys i got it all sorted. Ecu loads cal's, comes online, car starts, fuel pump is running, tacho is working. But when i doing a datalog and press record, no live data is showing on laptop in rpm etc no movement. So when i stop recording datalog to view log it opens blank. What can i check for?

ok i will do, but based on the wiring does all look good? Please assist me buddy i in south africa and difficulty to get advice or help on it, just want to get my car running

masked around case
http://i110.photobucket.com/albums/n101/bac1_2006/kpro1pic.jpg

in J250, a 'O' chip that was left unchanged
http://i110.photobucket.com/albums/n101/bac1_2006/kpropic22.jpg

pins all correctly placed, kpro board clips in easily
http://i110.photobucket.com/albums/n101/bac1_2006 ...

- serial number of your K-Pro. Chrome sticker, 10155
- ECU part number . 37820-PNF-A032091-308040
- KManager version. 3.1.1
- the calibration. don't have as car doesn't start
- a datalog of a problem. don't have
- what sort of vehicle you have. Civic 99-00 ek
- anything about the car which has ...

Guys I going crazy! Ok, after blowing my first PND ecu thinking it was a mechanical fault as no fuel was coming through, I now went and sourced a PNF ecu, transferred and soldered/wired kpro III in correctly, wired up new k20a2 harness and rywire ek harness. I plug laptop in, kpro states online ...