Hondata

Thanks for confirming

In CAN output documentation there are values for knock/detonation in the Hondata CAN protocol, though it’s noted this is only available on kpro.

I’m using an s300 v3 in a p72-a01 with knock board so in this case values should be in the ecu. Will the s300 send these in this case or does the s300 ...

Confirmed CAN documentation doesn’t seem to show it but TPS value is signed. It also seems to be the unscaled value, which in my case is about -.12% leading to the initial odd value.

I’m confused by the lambda value. Documentation shows conversion formula 32768/ lambda (lambda) which I read as ...

So yeah, I must have been stuck on stupid and had CAN (1&2) swapped so kept sniffing the non active network. Working now with a few weird behaviors.

TPS specifically seems to come in @65000+ until a little pressure on the pedal then registers (still need to compare if there’s any off set) thinking ...

Hi,
Im trying to set up CAN output from my s300 to a RaceCapture Pro Mk3. Everything appears to be setup correctly but I’m not receiving a signal on the RaceCapture.

Following wiring diagrams for the devices CanH and CanL are properly connected. A 120 ohm resistor was wired between H/L near the ecu ...

Did anyone figure this out? Seeing same thing with PLX AFR to b6. Using "Stock ITR" calibration until apt with Church for tune.
Will try to catch logging but pretty random. Just don't want to take it in for tune if there's an issue with wideband.

Suspecting it could be my ground. I used factory ...