Hondata

Thanks for the reply.

I appreciate it being a difficult situation. I will fill in my details for an RMA Request.

Ta

Hi.

Thanks again for the quick reply, and sorry for my delayed one, my email notifications must be broken.

I understand for yourselves it's probably not economical to fix.

What sort of money would I be looking at here? I built the car over 3 years while I was an apprentice did all the work ...

Yeah that's the conclusion I came to. Based on some signal wires that got hot I think it has somehow put power down the digital input. As the 3.5mm aux cable on the wideband shows some sign sof melting.

Car is my k20 swapped MR2. ECU is PRA I think. For UK spec Cars has been Dyno tuned in 2022 and ...

Hi.
My apologies for the delay I was going through the retailers process.

Kpro board is number 52121 on the sticker. And 32653 in the softwhere

Softwhere is showing as 14.9.15.1 and firmware as 24.00

Voltage is 11.8 while cranking. But starts fine then dies after 5 to 10 seconds with relays ...

Hi.
I have a kpro 4 I bought from a UK retailer a few years back.

After getting the car out the garage where it overwintered I have had an ECU fault.

Long story short it needs at the very least a firmware reset and is possibly physical damage to the ECU so I wanted to investigate my options.

To ...

Hi.
I have recently got my Kpro 4 running, and I have been able to data log basic OBD channels over the Bluetooth using an app like torque pro.

I want to log some of the Kpro 4s analogue channels as I have both oil and fuel pressure sensors setup on them and it would be useful to look for things ...

Got it dynoed and it made 203 at the Hubs so am happy with that.

Needed shitloads of tip in fuel which makes sense I guess.

Appreciated, I get a incorrect internal wireing code whenever I load a non PRA basemap so unfortunately need to use the PRA basemaps and there is only 4 to chose from. I suspect the best thing to do is open a basemap that more closely matches mine and copy values across to the current working basemap.

Hi. I have a euro k20 installed into a MK3 mr2. I have got a 74mm throttle body on a ported and polished intake, stock injectors (might swap to RDX ones if required down the road). The k20 is stock internals with a nice equal 4-1 3inch header and 3 inch exaust with hi flow cat and straight through ...

Cheers
I will take it up with them
it seems like kind of an oversight

Hi
I have recently bought a KPro ecu from Tegiwa (ECU part number PRA-E12)
one of the reasons that I went with the KPro was the digital inputs to allow me to run a PLX Wideband,
However upon receiving it I see that the case is sealed by warranty tags and as such I will not be able to use the ...