Hondata

I doubled the fuel from base for the ECT ranges below ~50F. Engine still will not start w/ ECT below 32F. I followed this thread below. I plugged in a brand new, room temperature, water temp sensor into my engine harness, with ECT actually at 15F. The car fired up immediately. K-pro gets 70F ECT ...

Add fuel to (parameters,fuel trim) Cranking Base injector pulse under freezing.


Decreasing number for injector pulse (ms) increases fuel, correct?
I adjusted the numbers for below freezing under Cranking base injector Pulse by -30%. Car still won't start. I can't tell if it's lean or rich ...

'05 Civic D17A2, problem is starting the car after it's sat outside through the evening & overnight in below freezing temps. It won't start this morning after the temp hit 0F, last night. IAT & ECT is 22F, right now, the next morning. It'll crank for several minutes, if I try.
-It seems like my ECT ...

KPro SN: K-Pro4 52738
ECU PN: 37820-PND-A06
ECU SN: 2062-602504-0C25
Current K-Manager installed: 4.4.3
D17 AEM Timing Gear

I'm swapping a K24A + EP3 transmission (4.7 FD low-freq VSS) with Z3 6-speed gearset, Z3 4.7 final drive + LSD.

I want VSS, and reverse lockout to work on my '05 Civic.
I ...

Update:

I forgot to plug in the EVAP Temp Sensor.
The A/C works normal. I had it fixed back in Sept. 2020.
I swapped the two sub-wire harnesses under my dash to M/T, from A/T, along with a matching Multiplexer for a '05 M/T EX Coupe.
I had to unplug the EVAP Temp Sensor to thread the ECM wire-loom ...

I'll troubleshoot some more than. Multiplexer is set to normal in K-Manager, and everything else seems to be functioning through the multiplexer.
I didn't change any wires.
The '04-'05 Civic EX Coupe M/T ECM sub-wire harness already has the SHO2S on the E connector with white, red stripe wire in E2 ...

I apologize for the late response, Spunkster.

KPro SN: K-Pro4 52738
ECU PN: 37820-PND-A06
ECU SN: 2062-602504-0C25
Current K-Manager installed: 4.4.3
D17 AEM Timing Gear installed.

2005 Honda Civic EX M/T, all factory.
E18 on my car is a red wire for the A/C clutch.
A/C Compressor is a three ...

My wiring is completely stock, D17A2, 3-pin A/C compressor, connected to factory harness.

ACSW does not show as being activated in K-Manager when I press button in cabin. No green light comes on when I press switch.

A/C worked before K-Pro Install.

Do I need to switch some pins around on the ...

The issue was bad grounding. HAMotorsports was super helpful and walked me through troubleshooting.

I had to dremel brush the two grounding contacts on the thermostat housing, the threads, the bolts, and the ground on the transmission bracket.

It started behaving completely normal after that. It ...

Hello,

I installed a KPro D17 kit from HAMotorsports. I'm having trouble getting the car to start with the .kal I uploaded. AEM timing gear was installed at a professional shop with a new timing belt and tensioner. I'll list all the information below.

The car cranks, but, does not start.

Also ...