Hondata

Well I got my Hondata/Omnipower 4 bar map sensor. First thing I did was pressurize it to 30psi holding the sensor in my hand. helf fine there but 35 psi blew the cases apart. it's not a big deal tho, looks like cheap permatex clear silicone holding the halves together, but again, this is me testing ...

Wouldn't be 100% accurate, but why don't you pick your tranny in the gear ratios section, then manipulate the ratios so they are more "equal" with the enlarged tire size.

Will there be provisions for playback? Would be very handy.

RPM, Speed, and the Gear Ratio Values.

Before I go and upgrade software versions again, what is the new in V 1.3.3 vs 1.3.2?

So I have version 1.3.2, have yet to upgrade to 1.3.3 as I'm a bit weiry. Ever since upgrading from 1.3.0 to 1.3.2, all my af's were leaner in boost by over a whole 1.0. After retuning it, it wasn't a big issue, I did notice one thing when I was idling and turning on the datalog via switch hooked to ...

what part# is your GM map?

P28 ECU doesn't have a knock sensor board, that's why it's throwing a code as it's looking for this on the ecu.

Must be an isolated case as my CEL shift light has worked for every version except the new 1.3.3 as I have not yet tested it.

Here is mines:
http://gallery.tchleung.com/albums/Turbo-Build-4/Virtual_Dash.sized.jpg

turbotypeR: Double click on the button you want to adjust, then go to font value colour or somethin along the lines of that. There will be one that is default blakc, change that to white so you can see it say ...

Wow once again Hondata amazes me. :D:D

Have car/ecu on, Smanager loaded, connect cable. Goto the menu bars uptop click "DATALOG", then "Download from ECU..."

So what's the problem exactly? Your logging more IGN timnig then the maps say? Cause not for me it doesn't. I downlaoded your tune with the log and it's dead on. If not reading a bit lower then the maps.

PS: boostedcivicsir, what's with all the I am not GOD ? I thought it was a typo at first, but ...

as long as the PTE's are peak and hold, why not?

Juset setup the activation to whatver output you want in the list... Put a wire to that pin(if ther already isn't one) and run it to a switch and run switch trigger end to ground.