Hondata

I'd rather not spend another 90 plus dollars in shipping for you to tell me the same thing. You already looked at this.

I'm trying to get some info on how you bench test these so I can eliminate the car.

I tried to do my best with asking specific questions, posting detail photos but none of ...

12.3v on a charger 13.7v

Is there any info you can give me on how you bench test these?
I'm sure you don't put them in a car to test but a bench top rig.

What are the power and ground wires you provide to the ECU for bench top testing?

I can then inspect those pins on my vehicle to make sure ...

K-Pro4 SN: 70176

Failed.
Not sure if its important but ignition was ON. After it failed Displayed Ignition OFF.
Cycled key and ig on returned.

What am i doing wrong?

Could it be something with my vehicle wiring? I would guess the strict USB connection from Laptop to the ECU would mean none of that would matter short of power to the ECU. I would also assume that is correct since it detects "Ignition on" in the KManager software.
If there ...

By default when i select that map the Enable Immobilizer is already unselected.
I select the Upward Arrow on the display panel "Upload Changes To ECU" it has a green progression animation till about 75% then stops.
Stating Upload fail

when changing the Calibration for my situation is the correct method.....
New Calibration>VehicleType>Other Vehicles>k24-accord-stock.kal ? My ECU is an Auto PND

This is what i first see when turning Ignition on * see attached.

Drivers installed, Online, Ignition on. I also get the little temp pop up "ECU connected" on the datalog tab.
Is this the correct boot up sequence?

As you an see the Immobilizer is enabled on the settings. So i can NOT start the ...

Can someone please help me with a walk though for first start up in a virgin Kpro?
Unable to upload new calibration. Sent ECU back to Hondata to check it and they said there was no issues with the ECU.

Contrary to the public documentation my system does not list the Kpro under "Universal serial bus ...

Thanks I contacted them.

Do you think it could be anything else?
Like a blown fuse or damaged wire?

What is required of the ECU to be able to communicate via USB? I'd like to check to make sure the ECU is powered where it needs to be etc.

Like I stated before this a totally new setup. New ...

I checked and looks like the board is fully seated on the headers. I lightly pressed down in those spots to double check. No movement.
Tried uploading map again and failed.

I left the shop but I will try that tomorrow. Thank you for all the assistance so far.

I don't know if it matters but each time I get an error "ignition off" happens and I have to cycle the key to get ign on again.

Clear security failed

New Calibration tab top left~vehicle type menu~other vehicle~k24-accord-stockk.cal~ select OK.

Cycled key to get "Ignition On" prompt in the lower left of program

Then hit upload. Start updating 25% green bar the says..
Upload failed.

Ive tried different programs the same method to see if I can ...