Hondata

If you already tried uploading a calibraton file then it seems that you are having problems with the soldering.

Have tried uploading a calibration?

open your Smanager. Go to parameters -> miscelaneous and tick disable knock sensor.

Recently i was perfectly running on a v1.2.9 of the Smanager. And as a matter of fact, I get through the emission testing using that old version. But eventually last night when I was checking for updates, I came across these latest version V 1.3.3 which I downloaded.

So then early this morning ...

farad is for capacitors. Maybe you mean farenheit.

laziebun wrote:they both just giveme the temp....

Look harder and you'll se the compensation percentages

At the time you had a boost cut, your boost was more than 10psi. Maybe you are having a boost spike.

They have a price list. Check it out.

Try your ECU in another car. If the injectors don't work, then it's your ECU that is causing the problem.

How's your fuel pressure? Ooops, It is in your statement.

Try replacing the injectors or fuel filter

what fuel pump are you using? what fpr are you using? i would suspect your issue is pressure/flow.

walbro255 and stock fpr readiong 48psi fuel pressure drops to about 43 in boost imma get a aftermarketand bump it up a few psi like to 50

when in boost your fuel pressure should rise higher than ...

sounds like a misfire.

try setting the vtec to 8000 first then tune. check if it goes away.

if it doesn't, post calibration and datalog

Vtec at 8k may damage the motor.

http://chewies.net/~raz/kpro/vtec-warning.png

the problem is at 6k rpm. setting the vtec at 8k rpm doesn't mean you will ...

Thgen start with a low value then gradually increase it until it reads the same.

If you need to know what value to start with, then read the manual in the help file.

try checking the battry voltage. anything under 11volts causes upload download problems.

sounds like a misfire.

try setting the vtec to 8000 first then tune. check if it goes away.

if it doesn't, post calibration and datalog

go to settings.
then go to wideband tab.