01" Integra DC5 with few mods

I-BEX · Post by **I-BEX** » Fri Feb 12, 2010 12:58 am

Good morning together,

my name is timo an i come from germany.

i have a honda integra dc5 (K20a) with following mods:

RBC Manifold
DC-Sports header
Greddy TI-C 70mm catback

have anybody a good map for this setup...?!

thanks in advance

kind regards
timo

keto06 · Post by **keto06** » Fri Feb 12, 2010 12:50 pm

What is the code on the KPRO'd ECU? PRB? PRA?

Do you have a wideband o2 sensor or the narrowband one that comes in the CTR?

I-BEX · Post by **I-BEX** » Mon Feb 15, 2010 12:33 am

Hi,

the code of my ecu is PRC

and

i have a wideband o2 sensor

regards
timo

keto06 · Post by **keto06** » Mon Feb 15, 2010 1:00 pm

Race Header or Shorty Header?

Stock Intake Pipe?

I-BEX · Post by **I-BEX** » Tue Feb 16, 2010 12:29 am

i have a race header and a stock intake pipe

regards
timo

keto06 · Post by **keto06** » Tue Feb 16, 2010 12:50 am

You may have to modify it a bit due to your unusual setup but this should get your started.

I-BEX · Post by **I-BEX** » Tue Feb 16, 2010 7:38 am

thanks a lot.

i´ll try it and let you know

regards
timo

I-BEX · Post by **I-BEX** » Thu Feb 18, 2010 6:21 am

keto06 wrote:You may have to modify it a bit due to your unusual setup but this should get your started.

hi,

i have another question.

is this map also good if i have a decat installed ?!

thanks in advance

regards
timo

keto06 · Post by **keto06** » Thu Feb 18, 2010 4:08 pm

Yes but if you dont want the CEL you will have to enable the emissions checking box.

I-BEX · Post by **I-BEX** » Fri Apr 09, 2010 8:49 am

hello together,

however i have not the 70mm catback only the 63 mm.

here is my tune. but without the rbc intake.i install the rbc next week
what you think about the tune?

keto06 · Post by **keto06** » Fri Apr 09, 2010 10:06 am

thats a PRB kal. You need to change it to make it work with what you have.