Hondata

The good news is that the ECU is not in recovery mode (all the uploads worked). The bad news is that this means that the ECU died somehow on its own.

You could switch the ECU & FlashPro to another vehicle to see if they communicate (the immobilizer wont' work, but at least you would be able to check for communication and possibly unlock the FlashPro).

Otherwise call for a RMA and make sure to send both the ECU & FlashPro so we can unlock it.

We put the used ecu & key in last night, still a no start. The wierd thing is when we hooked up our scan tool up, the tool froze up. We had disconnect the battery so the tool would reboot. There must
be a short to ground that is killing the data stream. we going to check every wire coming out of the ecu this weekend. Any idea's or tips out there.