Page 4 of 4
Re: B16a fully Built, OBX turbo, RC1000cc, Ran good with chipped ECU, Installed s300 I cant get to run!!!!!!
Posted: Wed Jul 29, 2015 5:23 am
by AREA876
Use Ctrl + L to clear previous recordings
Re: B16a fully Built, OBX turbo, RC1000cc, Ran good with chipped ECU, Installed s300 I cant get to run!!!!!!
Posted: Thu Jul 30, 2015 1:39 pm
by cbye
Now during deceleration it leans out, does that affect estimated values??? Car is running pretty well, just striving for perfection..... I love this s300=) best thing since sliced bread!!!!! Lol
Re: B16a fully Built, OBX turbo, RC1000cc, Ran good with chipped ECU, Installed s300 I cant get to run!!!!!!
Posted: Thu Jul 30, 2015 1:48 pm
by cbye
but i messed with the MAP sensor min and max values for graphing and cant get it to read right now?? what are default settings????i want read down to 30in vacuum and up to 20psi??
Re: B16a fully Built, OBX turbo, RC1000cc, Ran good with chipped ECU, Installed s300 I cant get to run!!!!!!
Posted: Thu Jul 30, 2015 7:35 pm
by AREA876
Try -29.53 min and 28.82 max for MAP display
Re: B16a fully Built, OBX turbo, RC1000cc, Ran good with chipped ECU, Installed s300 I cant get to run!!!!!!
Posted: Fri Aug 21, 2015 3:09 am
by cbye
Ok I'm getting the calibration more dialed in, but my idle is in 3rd column??? Is this normal??? My throttle body doesn't have adjuster screw for idle???? I'm chasing 14.7!!!!!! Idles at 1000 even thou set to 800.... should I adjust throttle plate to remain open slightly??? Seems to slam shut anyway.... it's Fullblown Motorsports 74mm?? I emailed their tech support about there being no adjuster screw and no reply!!!! Horsesh*t customer service!!!!!!!!!