Hondata

i went through this thread and haven't seen it yet so...

A temp controlled output to activate an electric water pump,
just like the one for rad fan.

I don't have one but I thought it was a good idea.

Another option for widband logging. Being able to log only a selected gear. this will clean up alot of Overrun when on dyno or street. Just be able to make a check box for N-5 gear also have a lean stop logger so if your wide open put 16 as lean over by the time you see 16 in wot you should have the foot off the gas pedal anyways, or you could set it up as dont log fuel cut.

Cold Limiter like a stock ECU.

Boost by VSS would be good

I'd like to see error codes on the display function

FreshDA9 wrote:Another option for widband logging. Being able to log only a selected gear. this will clean up alot of Overrun when on dyno or street. Just be able to make a check box for N-5 gear also have a lean stop logger so if your wide open put 16 as lean over by the time you see 16 in wot you should have the foot off the gas pedal anyways, or you could set it up as dont log fuel cut.

-Plus, when looking at recorded Lambda and going to make a change. after changing the cell can you make it so that 1 cell clears itself. i have started making changes in maps before then customers interrupt me and i forgot where i have already made changes. think this would help us ADD people. thank you.

yes something along those lines would be nice freshda9.

i would like to see ability to datalog idle valve duty,is it possible?
would prob help troubleshooting some idle fault situations a bit easier

Make K-Pro work with B series engines.

We would get way more input outputs. Maybe even 8 injectors.
We would get individual coils @ a cheaper price.
We would get extrenal trigger.

I dont know guys I think I am on to something..

Hondata its time to give b series some love! Not sure why it can not work. My buddy is running a VW off of s300.

I would like to see rpms for each gear so we can have different rev limits for each gear.
This would help lots of people so you wont have to shift into 5th gear in the 1/4. also would make for 1st gear a higher rpm or whatever gear you want to change

also a idle target lambda would be nice to like the k-Pro

I would also like to see the ability to lock the chip with a password so no one can open or download the file unless used with a password

jun1or wrote:1.) I'm sure it's been mentioned before, but a vertical scroll bar in smanager would be nice.

I run smanager on a netbook (7 hour battery FTW!) but it only has 1024x600 resolution.

2.) The ability to type capital I and D in notes (I believe keys are mapped to "Increase Selection" in the edit menu)


Keep up the good work hondata.

Jun1or

this is really important!!

VT-Doo wrote:I'd also like to see some sort of anti-theft function,
like the car has to be in a particular state before the car can start.
i.e. brake, clutch, aux switch, etc.

Also agree with the shift light functions mentioned above.

x2 on the anti theft.

In Crome Pro theres options to select certain injector information. For example High or Low impedance injectors and the voltage compensations, & by manufacturer.That way everything is dialed in for you as far as MS's and dead times etc. Is there any ideas of ever making or adding an options like this for at least a majority of the leading injector manufacturers. I know theres compensations but maybe this would help many people tune there cars.

How about a Hour meter??
for those with new engines.