PLEASE HELP!!! datalog and kal posted

D-Clem · Post by **D-Clem** » Sun Mar 14, 2010 6:40 pm

setup-03 k20a2 stock engine, RBC manifold, Karcepts CAI with v-stack, dc header

****edit**** i have found a map that lets me full throttle, its a map that my buddy runs on his k24a2 but its not perfect by any means. i will post the datalog and the .kal
datalog was a second gear full throttle pull

D-Clem · Post by **D-Clem** » Sun Mar 14, 2010 6:41 pm

and heres the datlog-second gear full throttle pull, please help me clean this up

keto06 · Post by **keto06** » Sun Mar 14, 2010 11:48 pm

That map is no good for your setup.

This one should be much more to your liking.

D-Clem · Post by **D-Clem** » Mon Mar 15, 2010 6:15 am

i tried that one already, it runs terrible, it leans out horribly up top. the one i posted atleast keeps my a/fs semi good and allows me to full throttle

keto06 · Post by **keto06** » Tue Mar 16, 2010 8:06 pm

add some fuel then. LOL. no point in starting over for that reason. Using that TSX map you are killing yourself.

D-Clem · Post by **D-Clem** » Tue Mar 16, 2010 9:39 pm

yea, i did that and it seems to be a lot better im just new to the whole kpro deal and didnt really know where to start

keto06 · Post by **keto06** » Wed Mar 17, 2010 1:07 am

set lean protection at 14.2, add 10% fuel to columns 8-10 if you were hitting lean cut before, do another pull for me.