Lookin for a kal

K-Series Programmable ECU Calibration updates / downloads
Post Reply
montygreenvr6
Posts: 6
Joined: Sat Mar 20, 2010 4:32 pm

Lookin for a kal

Post by montygreenvr6 »

I just picked up an ek hatch with on 04 k20a2 swap, it has and rbc, skunk2 70mm tb, rc 440's 3'' intake tube with 5'' blox filter, rcrew header, 2.5 exh without a cat has a resonator and a muffler lightweight flywheel and i think that covers it. The car is also running no iac or secondary 02. any help would be appreciated. The map the car has in it now is a stock a2 map and it runs like complete shit will not idle unless i hold it there for a min and then falls on its face. Thanks guys.
keto06
Posts: 507
Joined: Fri Jul 17, 2009 9:29 pm

Post by keto06 »

Try this one. Post a log if you need help.
You do not have the required permissions to view the files attached to this post.
montygreenvr6
Posts: 6
Joined: Sat Mar 20, 2010 4:32 pm

Post by montygreenvr6 »

So keto the map cleaned up my partial throttle parking lot putting around but the car now wont rev past 5600 rpms in any gear. when in neutral it will rev fine but when under load it wont rev like hitting a limiter. Thanks.
keto06
Posts: 507
Joined: Fri Jul 17, 2009 9:29 pm

Post by keto06 »

try again :P
You do not have the required permissions to view the files attached to this post.
montygreenvr6
Posts: 6
Joined: Sat Mar 20, 2010 4:32 pm

Post by montygreenvr6 »

Nope same thing sorry man.
montygreenvr6
Posts: 6
Joined: Sat Mar 20, 2010 4:32 pm

Post by montygreenvr6 »

Am i doing something wrong ?
keto06
Posts: 507
Joined: Fri Jul 17, 2009 9:29 pm

Post by keto06 »

datalog?
montygreenvr6
Posts: 6
Joined: Sat Mar 20, 2010 4:32 pm

Post by montygreenvr6 »

Ok ill datalog until my intermittent o2 sensor problem rears its ugly head
montygreenvr6
Posts: 6
Joined: Sat Mar 20, 2010 4:32 pm

Post by montygreenvr6 »

it wont let me post my datalog
Post Reply