Hondata

hello
well iv tuned a car, and saved several maps while tuning it,
when i disconnected the laptop from the s300 and left the costumer he wasn't able to restart the car, i returned to the car with the laptop. uploaded the last map again, and it will start only one time while i'm connected to the s300, while i dissconect the laptop the car wont restart again, only after i will upload a different map start it on the different map, upload the last map again and so on.....
eventualy i didnt understand why the car didnt start, i copied the fuel and ign maps to the last skl that will start the car, and let the costumer go,
after that, i compared the last file and the file before that and suddanly i see that the parameter securitytpsenabled is ON, on the last file, but i never turned it on!!! what could cause this ?

From Help, About, what is the version of software you are using?

What is the serial number that is on the s300 inside the ECU?

2.5.2.0

34923

Tell me step by step exactly how you are uploading. Are you downloading the calibration from the s300 or are you using a calibration stored on your laptop?

Can you post the calibration in question?

nothing special,
I never download from the ecu unless i dont have my skl's with me,

connect usb,
open s manager and confirm its online,
open new file or open my own last tuned skl,
and upload....

when i finish tuning sometimes i close the software before i disconnect the laptop, sometimes after, what is the "correct" way?

is there a chance that something like this will happen that it matters how i upload or download my files?

Tell me exactly what and where you are clicking when you upload.

online / upload, am i missing something? i already said, i tuned the car....

?

You have not provided the calibration in question still.