Hondata

I recently installed a Hondata Boost control solenoid on my 98 integra (P28 OBD1) and cannot get any response from it for the life of me . me and my tuner are stumped hes tried every setting possible and all im getting is waste gate . I have one wire tapped into A11 and the other tapped into A25 (read online this is a good switchable 12V source) ive tried multiple power sources and cannot get any response at all from the controller . i know the solenoid works because i touched the wires on the battery and the solenoid clicked/engaged but i cannot get it to engage when wired into the ecu/ setup for the life of me . any ideas ? tips ? things i may be doing wrong ?

Have the components been added to the ECU for it to be able to control the solenoid?

https://hondata.com/help/smanager/boost ... tsub=boost

Hmm didn’t realize this was a thing so I guess not Lol . Is there certain types of diodes/transistors I need ? Or just general ones work ? Anyone have a video guide on doing it ?

The components are available at: https://hondata.com/accessories/boost-c ... uage=en-gb

Shit I was hoping to be able to get them somewhere local ….. I’ve already had the car laid up for a week or two trying to figure out this issue

I’m trying to take the s300 out of the car now to bring it somewhere to get soldered but I literally cannot get the clips out of it for the life of me I’m pushing the clips down so hard and pulling but the plugs will not come out

Nvm got it out