Hondata

In a couple of weeks, I'll be adding some bolt ons all at once, including a KT 72mm TB. I've been running a great stock tune for a few years done up by our old friend EFICU (where did her go btw? It's been a minute and a half), so I'm looking to build off it with the new parts. What are some of the basic parameters I'll need to adjust, and by how much, just to be able to drive it around until a slot at a dyno opens up? Thanks!

KT 3" CAI
KT 72mm TB
KT 4-2-1 Tri-y Header
Invidia Q300 exhaust

You would have to adjust the fueling to make sure the car is not running lean. You will also have to adjust the timing if knock is present.

-Ed