Page 1 of 1
9TH GEN WHAT ECU PIN DO I HOOK UP ELEC. BOOST CONTROLLER?
Posted: Tue Oct 21, 2025 10:23 pm
by Texas_guy
Hello 👋 thinking about going turbo but I know on 8th gen its pin b29 or something on the ecu connector is it the same on 9th gens too??
Re: 9TH GEN WHAT ECU PIN DO I HOOK UP ELEC. BOOST CONTROLLER?
Posted: Wed Oct 22, 2025 7:49 am
by Hondata
Re: 9TH GEN WHAT ECU PIN DO I HOOK UP ELEC. BOOST CONTROLLER?
Posted: Mon Nov 10, 2025 11:01 am
by Texas_guy
Please lmk when back in stock??
Re: 9TH GEN WHAT ECU PIN DO I HOOK UP ELEC. BOOST CONTROLLER?
Posted: Mon Nov 10, 2025 12:06 pm
by Spunkster
Please email
store@hondata.com to order this.
Re: 9TH GEN WHAT ECU PIN DO I HOOK UP ELEC. BOOST CONTROLLER?
Posted: Sat Nov 15, 2025 9:53 am
by 3papii
Need help so apparently I installed my Hondata CanBoost for 9th gen civic si last week it was working fine then suddenly it stopped working this Monday(Nov 10, 2025). I rechecked everything everything seems fine I even tested the 4 port solenoid but it was fine I even did reflash my tune still nothing my boost cont duty still says 0 and whenever I tried to do a pull to see if its working still says 0. I only hit 7-8psi which is wastegate pressure only so now I'm stuck and dont know what to do if y'all see this please help and thank you for your time.
Re: 9TH GEN WHAT ECU PIN DO I HOOK UP ELEC. BOOST CONTROLLER?
Posted: Mon Nov 17, 2025 9:56 am
by Spunkster
Post the calibration and a datalog showing the issue.
Re: 9TH GEN WHAT ECU PIN DO I HOOK UP ELEC. BOOST CONTROLLER?
Posted: Wed Nov 26, 2025 11:02 am
by 3papii
My tune is lock is that okay?
Re: 9TH GEN WHAT ECU PIN DO I HOOK UP ELEC. BOOST CONTROLLER?
Posted: Mon Dec 01, 2025 2:32 am
by the GTR
3papii wrote: Wed Nov 26, 2025 11:02 am
My tune is lock is that okay?
im sure they can unlock it, post it up.
Re: 9TH GEN WHAT ECU PIN DO I HOOK UP ELEC. BOOST CONTROLLER?
Posted: Mon Feb 16, 2026 8:41 pm
by Rynoryt
I have same problem.
K24 Mapa Turbo V24.fpcal
Datalog000.6 16.02.2026.fpdl
My tune sometimes enables the Boost control target, but other times it doesn't change at all... and only works with spring pressure. It doesn't go above 3/4 psi.
Can anyone tell me if I'm configuring it wrong?