Because when I rev the engine in neutral, it sounds retarded and slow.
My datalog shows that it's not following my ignition table.
Is this because I should set the values to "0" where it says "tip in retard A/C off"?
I tried setting those values to 0, but the same thing still happens.
ecu prb kpro v4
ignition table not responding
ignition table not responding
You do not have the required permissions to view the files attached to this post.
Re: ignition table not responding
any answer to this event
Re: ignition table not responding
Any suggestions as to why this is happening?
Re: ignition table not responding
these blips are too short to really make anything out about it.
Re: ignition table not responding
If I accelerate slowly, it follows my ignition timing tablet perfectly; if I accelerate quickly, it doesn't.
What would be the specific function of "tip in retard a/c off"?
What would be the specific function of "tip in retard a/c off"?
Re: ignition table not responding
Post the calibration and datalogs showing this.