Hondata

Because when I rev the engine in neutral, it sounds retarded and slow.
My datalog shows that it's not following my ignition table.
Is this because I should set the values ​​to "0" where it says "tip in retard A/C off"?

I tried setting those values ​​to 0, but the same thing still happens.

ecu prb kpro v4

any answer to this event

Any suggestions as to why this is happening?

these blips are too short to really make anything out about it.

If I accelerate slowly, it follows my ignition timing tablet perfectly; if I accelerate quickly, it doesn't.
What would be the specific function of "tip in retard a/c off"?

Post the calibration and datalogs showing this.