Hondata

Sorry if this seems like a simple question but I searched around on the forum could not find a similar post. I have a b16A with basic bolt ons and I loaded the stockjdmp30 calibration. Will I be fine running on just this without getting it tuned? I plan on putting in a turbo next year and was going to get it tuned after everthing is done but I am worried about causing any damage now with just the base calibration. I drove around a little bit using this calibration and it seemed to drive fine. Will I be okay with just using the stockjdmp30 calibration file?

It is really hard to say without a wideband reading to make sure it is not running too rich or lean.